Store-bought drain cleaners dissolve soap and light grease. They do nothing for root intrusion, grease buildup 40 feet in, or a collapsed pipe segment. Masters Plumbing Service's Drain Cleaning team in Nash arrives with professional-grade augers and hydro-jetting units that actually resolve the blockage.
📞 Call +1-855-718-1500 — Book Today
Every drain call we run in Nash, TX starts with identifying what type of blockage you're dealing with — because the method that clears a grease blockage efficiently is different from the one that handles root intrusion.
Hydro-jetting is the only method that restores full pipe diameter. A cable auger punches through a blockage; a jetter removes the blockage material from the pipe wall entirely, significantly extending the interval before the next cleaning is needed.
Before recommending any clearing method, we run a push-rod camera into the drain to visually confirm blockage type and location. Grease accumulation 30 feet in looks different from a root ball at a joint or a collapsed section — and each requires a different response.
Whether it's a backed-up bathroom sink or a full house sewer drain stoppage, our team carries the right nozzle sizes and cable diameters for the specific pipe we're clearing.
We photograph or record camera footage of the drain before and after clearing so you can see exactly what was there and that it's gone. Every job comes with a flat-rate quote before any work begins — no hourly-rate surprises.
From a slow bathroom sink to a full main-line stoppage affecting every fixture in the house, our drain techs in Nash, TX have the equipment and training to clear it.
Kitchen drains accumulate FOG — fats, oils, and grease — that solidifies on pipe walls and progressively narrows the line. We use a combination of a cable auger to break the initial plug and a hot-water hydro-jet pass to scour the residual grease film. For commercial kitchens, we also service grease interceptors and document cleaning for inspection records.
Chronic slow bathroom drains often point to a partially closed p-trap, a buildup on the overflow plate mechanism, or a drain arm pitched incorrectly. We clear the immediate clog and identify if a mechanical fix is needed to prevent fast recurrence.
Root intrusion at pipe joints is the leading cause of main sewer blockages in homes over 20 years old. Our electric root cutter attachment on the sectional cable removes the root mass; we then scope again to confirm the line is clear before pulling equipment.
Basement floor drains and laundry room drains often go years without cleaning and can develop sediment, lint, and mineral scale blockages. We clear these drains with an electric snake and flush thoroughly to confirm full flow before closing out the job.
Restaurants, multi-family buildings, and homes with chronic grease or root problems benefit from scheduled hydro-jet maintenance on a 12–24 month cycle. We map the drain system, document baseline camera footage, jet the lines, and re-scope to confirm clean pipe walls. This approach prevents emergency backups rather than reacting to them.
Sometimes the question isn't just "why is this draining slowly" but "what is the actual condition of this pipe system." We run a recorded CCTV inspection with distance markings and provide a written report noting blockage types, root intrusion points, joint offsets, pipe material, and any visible structural defects.
We don't show up and start snaking blind. Our approach uses a camera-first diagnostic protocol to confirm what we're clearing before selecting the method.
Your description lets us load the right equipment before we leave the shop. Main line call vs. single kitchen drain is a different tool setup — knowing ahead saves time on site.
The camera also gives us the distance to the blockage and confirms the pipe diameter — both factors in selecting the right clearing method and nozzle size.
Based on the camera findings, we present you with a flat-rate quote and explain exactly which method we're using — electric auger, hydro-jet, root cutter — and why. No work begins until you approve.
If anything was found during the camera run that warrants monitoring or repair, it's noted in the written report so you have a record — useful for planning future maintenance or a repair conversation.

Called about a kitchen drain that three other plumbers had snaked without long-term success. Masters Plumbing Service ran a camera first and found grease buildup 28 feet in, past where any hand snake reaches. Hydro-jetted it, re-scoped to confirm clean, and the drain has run perfectly in the months since.
All three bathrooms drained slowly and the lowest floor toilet gurgled every time an upstairs fixture ran — classic main line partial blockage. Masters Plumbing Service's tech accessed the cleanout, ran the camera, and found root intrusion at a clay tile joint about 40 feet from the house. He cut the roots with the root cutter attachment and re-scoped to confirm clear flow. Also noted a joint offset at 68 feet that we'll need to line eventually — good to know before it becomes a full backup.
We own a rental property and schedule annual hydro-jet maintenance with Masters Plumbing Service. The jetting intervals have gotten the drain-related tenant calls down to nearly zero. The camera documentation each year also gives us a clear record of pipe condition over time.

Our drain technicians are based in and around Nash to keep drive times short and same-day slots realistic. We cover residential and commercial properties across Nash, TX.

Masters Plumbing Service's certified drain team is in Nash today. Call now to check same-day availability.
📞 Call +1-855-718-1500 Now